Insta360 Bike Headset Cap Mount
Couldn't load pickup availability
Bike Headset Cap Mount
Ride hard, shoot easy.
More flexibility.
Use the mount with your Insta360 cam for more flexibility over what you capture.
From immersive wide-angle POVs to incredible third-person shots, it's all possible.
Less fiddling, more pedaling.
The mount is lightweight, easy to use and install at home and has minimal impact on your handlebars.
Shoot any angle.
An adjustable design makes it easy to rotate whenever you need a new angle.
Get more creative freedom without interrupting your flow!
Center stage.
Capture cinematic wide-angle shots of your ride with Insta360 Ace Pro.
Adjust the universal joint as shown below to center the angle.
1x Bike Headset Cap Base
1x Universal Joint
2x Bike Headset Screw (20/30mm)
3x L-shaped Hex Key (3/4/5mm)
1x Thumb Screw
1x 3-Prong to 1/4" Adapter
2x Dust Caps
2x Anti-Slip Ring Sets
4x Anti-Slip Rings
74.17x74.12x53mm (2.92x2.91x2.08in)
31g (1.09oz)
140g (4.93oz)
Aluminum alloy, stainless steel, silicone, plastic
- This mount is only compatible with standard OD1 specification handlebars or fork steerers with a diameter of 28.6mm (1-1/8in). It is unsuitable for non-standard bikes, non-circular handlebar head tubes, etc.
- Ensure the mount is securely attached to the bike before attaching the camera. Tighten the mount using the included L-shaped Hex Key.
- Ensure the bike fork's nut is secure before installing the mount. It is recommended to use a star nut or expander plug. Star nuts with insufficient friction or strength are not recommended, as they may come loose. When using an expander plug, place it 3-4mm away from the end of the bike's stem.
- Place one Anti-Slip Ring Set onto the Bike Headset Cap Mount before tightening.
- Once installed, cover the Bike Headset Screw with a Dust Cap to prevent rusting.
- Wipe the accessory dry after every use to prevent erosion from water or sweat.
- This product is designed for cycling on smooth roads at a maximum speed of 50km/h (31mph). It is not suitable for off-road.
- This mount is only compatible with the Insta360 Action Invisible Selfie Stick. To ensure your safety when cycling, if you need to extend the selfie stick, please extend it horizontally away from the wheel. The length should not extend past the front wheel.
- If the bike is parked outdoors for an extended period, remove the mount and store it properly.
- Please follow these instructions to install and use this accessory properly. Do not perform DIY or connect third-party accessories. Failure or damage caused by not following the instructions is not covered by Insta360 warranty or exchange services.
